Designed by
3DTaiChi
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
Toy Model Airplane
Easy to assemble and print airplane. Very little support material required.
Print Settings
- Suggested Material:PLA
- 50mm/s
- 0.15mm layer height and 40% fill on body parts
- 0.08mm or less layer height, 90% fill on axle and prop shaft
- Support suggested for prop.
- Remove built-in support on bottom part
- 0.06mm 30mm/s, 20% fill for Ninjaflex Tires
Additional Instructions
The model is assembled using off-the-shelf 4-40 screws which can be found at any hardware store.
4-40 1/4" Screws: 11x
4-40 1/2" Screws: 3x
The tires can be printed from Ninjaflex or similar TPU. A hub+tire combined part is provided if Ninjaflex is not available. In this case, print the Hub_Tire part in regular PLA.
Design Files
File Size
Plane Body_Bot.stl
4.98 MB
Plane Body_Top.stl
7.34 MB
Prop_Shaft.stl
2.66 MB
Propeller.stl
8.3 MB
Spool.stl
3.6 MB
Tire.stl
1.31 MB
Wheel_Hub.stl
2.16 MB
Axle.stl
2.3 MB
Hub_and_Tire.stl
3.07 MB
Cockpit.stl
2.85 MB
Engine.stl
10.4 MB
Comments