XDSR Rubber Band Gun

https://youtu.be/znnO-5fZpPA

Update I changed the magazine so that it slides in easily but still stays in place.

Update I added a barrel plug so that if you do decide to print it in black you can attach an orange tip.

This rubber band gun modeled after a Springfield XDS 9mm PRINTS IN PLACE, no assembly required. That is right, no assembly, no glue, no screws. Just remove the supports load and fire. It includes a removable magazine to hold extra ammo. It fires #31 rubber bands so no need to spend money on over priced "rubber band gun ammo".

Below is a link to the rubber bands this is designed for. If you use stronger rubber bands, or load more than four shots it may result in failure of the rotor.

Alliance Rubber 96315 Advantage Rubber Bands Size #31 , 1 lb Box Contains Approx. 850 Bands (2 1/2" x 1/8", Red) https://www.amazon.com/dp/B008X09PDC/ref=cm_sw_r_cp_apa_i_Pp.KCb72JE91W

Because this is a highly detailed replica of an actual firearm, only print it bright colors to avoid it being mistaken for the real thing.*

Layer Height: 0.2

Supports: From build plate only, if you are using custom supports ensure to support the rotor and the axle is spins on. Also remove any supports that extend up into the body as they will be difficult to remove.

I also recommend increasing your support density to at least %50 or using a dense support layer to make sure the texture on the grips comes out well.

4 shells

Infill: 30%

Orient the model so that the barrel is pointed upward and tilted at a 15 degree angle towards the top of the gun as seen in the picture.