Xiaomi M365 tire valve adapter
Xiaomi M365 tire valve adapter
Published 2019-05-17T08:55:12+00:00
This will allow you to screw the pump extension supplied with the Xiaomi Mijia M365 electric scooter with ease, keeping more air in the tire.
MUST BE PRINTED in TPE/TPU, as the inner diameter is smaller than that of the metal connector. It is a press fit.
The technique is to cup your hand beneath like shown in the picture, apply pressure upwards against the adapter and pull your hand away in one fast motion in order to maximize its utility. Best if you start unscrewing from the point just before you hear air escaping. You could probably also use a string or flexible strip of material if it's still too small for your grip, kind of the way you start a lawn mower or spin a toy top. If I went with a diameter any bigger I reasoned that it would still take about the same time fussing without the adapter.
0.1 - 0.2 layer height recommended with nominal infill (10 - 30%). If you have trouble putting it on with your TPU you could go with thicker layers.
Verify in your slicer that you have your wall settings adjusted so that it will create at least 3 full walls (0.4 nozzle) around the opening.
Date published | 17/05/2019 |
Time to do | 20 - minutes |
Support Free | YES |