CTC - Lateral Fan Duct (for radial fan)

[EN]

CTC (mk8) lateral cooling fan duct, adapted for radial fan.

Compatible with all original CTC Bizer, for left-side extruder !

Cooling fan needed (50mm DC24v radial fan) :

https://www.amazon.fr/Aibecy-Ventilateur-Refroidissement-dExtrudeuse-Imprimante/dp/B071YGS944/ref=pd_sbs_328_2?_encoding=UTF8&psc=1&refRID=FT9Q61A7QW2D6HYPT58P

Advices:

• Don't forget to remove integrated support (see 10th picture)

• If necessary, add some adhesive tape (like shown on 11th picture) to adjust parts clamping!

• Print in 100% infill, at 0.2 maximum layer height, and without supports if posible (only needed support is already present).

Feel free to comment in case of problems or any question / suggestion you may have!

Don't forget to share your making ;)

#--------------------------------------------

[EN]

Side ventilation duct for 3D CTC printer (mk8), suitable for radial fan.

Compatible with all original CTC (mk8) 3D printers, for the left hand extruder.

Requires the following printing fan (50mm radial fan, DC24v) :

https://www.amazon.fr/Aibecy-Ventilateur-Refroidissement-dExtrudeuse-Imprimante/dp/B071YGS944/ref=pd_sbs_328_2?_encoding=UTF8&psc=1&refRID=FT9Q61A7QW2D6HYPT58P

Tips :

• Do not forget to** remove the integrated support** (see picture 10)

• If necessary, add some Chatterton tape (as shown in picture 11) to adjust the clamping of the parts!

• Print with 100% filling, maximum layer height of 0.2mm, and if possible without supports (the only necessary support is already present).

Do not hesitate to comment in case of problems, or if you have any questions/suggestions!

Don't forget to share your 3D printing ;)