Interior for RC4WD Hilux 2dr

This is a bolt-in ready 3d printer friendly interior for the RC4WD Hilux 2dr hard bodies. This is designed to work with the dash that generally come with these bodies at least in the kits.

I will be doing a dash in the future at some point.

I believe this will work with the Tamiya and the cloned versions of the Hilux 2dr, but I have not personally confirmed this yet.

I have this designed to work with the TF2 RWB chassis setup running an R3 trans. All my electronics (minus motor and servo obviously) are on the tray under the interior, including the 2200mah 3s lipo that I run in this truck, (links to the batteries I run below so you can see the size).

Print orientation is pretty straight forward, and yes this does require supports, it is minimal though.

For these I generally use ESun PLA Pro and have had excellent results. However feel free to use any material of your choice, (link to the material I use below)

If you have any questions feel free to message me. I try to be on top of getting back to people, I am sorry if the response is a little delayed, sometimes life gets in the way of the hobby.

Ovonic 2200mah 3S Lipo that I run in the standard battery location.
https://amzn.to/3f2FBGc

ESun PLA Pro that I generally use for parts like this.
https://amzn.to/3f2WJvp

This model does not require any special considerations for printing. As an operator of a 3D printer imagine you know your machine better than I do.
This model does require supports. Good luck and happy printing.