Fancy glasses 14 lenses

To party with your friends when the confinement is over, here are the fancy glasses with different clip-on lenses.

The glasses are easy to put on and take off (see video).

These glasses are very comfortable, they are based on existing eyeglasses.

Glasses and temples are to be printed together. The positioning is done automatically in Cura (as in the picture).

The counters print themselves at reduced speed.

Mounting :

Thoroughly deburr the glasses after removing the material supports.

Deburr the counters so that they can sink into the branches.

Then position the temples on the glasses correctly, you must see the holes of the temples aligned with those of the glasses.

Then push over the counters one after the other, force in the axis of the counter (so as not to break it) with your fingers or with pliers.

The pawn must be drowned in the branch.

If you want, you can put glue on the head of the pawn once it has been depressed.

Then heat the branches with a hairdryer to twist them slightly (at the ears).

There are 14 different pairs of glasses:

• Star Wars

• Star

• Cœur

• Scratched

• Star relief

• Super Hero

• Coronavirus

• Metal Music

• Pinhole

• Harley Davidson

• Peugeot

• Trooper

• C3PO

• Heart relief

Eyeglass and temple parameters in PLA:

Layer: 0.16mm

Wall: 1.2mm

Infill: 20%.

Material support : Yes

speed : 50mm/s

Brim: No

Parameters of the counters in PLA:

Layer: 0.12mm

Material support: No

speed : 30mm/s

Brim: 5mm

PLA lens parameters:

Layer: 0.16mm

Wall: 0.8mm

Infill: 5%.

Material support : No, just for star relief glasses, heart relief, C3PO

speed : 50mm/s

Brim: No