Beer tap handle SUPER Lupulo 3D / 3D HOP - Tap handle for chopper tap

SUPERLUPLE

Beer tap handle - Universal standard threaded tap handle. Prints and screws on without any problems!

Evokes the hop flower in 21 cm height with recessed handle. Can be taken from the middle or center, being a very durable design.

Design tested and printed many times as seen in the picture.

Beer tap handle with universal standard thread. It prints and twists smoothly!

Evokes the hop flowers - 21 cm height - Dettachable handle. It can be taken from the middle or center, being a very durable design.

This design was tested and printed many times as seen in the images.

Consists of 2 interlocking PARTS - 1) Handle 2) Hopstick

Can be PLA, ABS or PETG - 0,2mm

It doesn't need much infill, but I recommend at least 40% in the threading area and several outer perimeters.

Printing time 4 1/2 hours approximately.

No supports required! It is printed standing up. It is recommended to add raft with distance 0, and several perimeters to ensure adhesion to the bed.

THERE ARE 2 PARTS that fit together - 1)Hanlde 2) Hop

It can be PLA, ABS or PETG.- 0,2mm

Don't need much infill, but I recommend at least 40% in the thread zone, and 3 or more perimeters.

Printing time approximately: 4 1/2 hours.

No support Needed! I recommend raft with 0 distance and a few perimeters to allow maximun adherence