Board game Triominos

The dots of the printed Triominos must be coloured with indelible felt or painted black to have a similar effect.

Triominos rule:

Aim of the game: Get a maximum of points by arranging your Triominoes according to those already laid down.

Number of players: 1 to 3 players

Age: from 8 years old

Hardware:

2 Printable rulers on which to place your Triominos (Accessory file)

35 Triominos Printable.

Mixing: Spread all the Triominos face down on the table and mix them together.

Two Players: For a two-player game, each player picks 7 Triominoes.

Three Players: For a 3-player game, each player picks 4 Triominoes.

Pickaxe: The rest of the Triominoes make up the pickaxe.

Each player picks a Triominos.

Whoever has the highest total by adding up the numbers on their tile starts the game (in case of a tie, draw again).

First pose:

The first player chooses one of his Triominos and places it in the middle of the table.

He scores a score corresponding to the total of the numbers on the played tile, his turn is then over.

Each player, when his turn comes, must place a Triominos on the table next to a previously played tile in order to get a side in common (the two numbers of the two points must match).

A player may only land one Triumino per turn.

If a player cannot play, he draws a tile and places it if he can, otherwise his turn ends.

Draw Malus: Each time a player draws a Triominos, he loses 3 pts on his score.

When a player lands his last Triominos, he gets a bonus of 10 pts.

Blocked game: If no one can place a new tile, the game is blocked and finished.

The player with the highest score wins the game.

Empty pickaxe

If a player has to draw and the drawer is empty, he passes his turn and his score remains the same.

These 3D models belong to the brand "B.C Entreprise" and can in no case be put back on sale by a third party without its approval. However, the Group authorizes you to modify or improve the pre-existing model for your personal use. Any breach will automatically open a complaint against the offender(s). (Articles L 513-6 and L 613-5 of the IPC)

Support from 50° angle

In 0.2 with PLA at 206°.

Filling 30% to be printed without skirt or raft.