Mardi Gras Leaf Blower
Mardi Gras Leaf Blower
3D
Published 2020-02-12T00:10:12+00:00
Built this to use for Mardi Gras decorating. To complete this build, you will need to print four of the bearing adapters. You will need, 4ea 608 (7mmx22mmx8mmCenter) Roller Bearings, from fidgit spinners. 2ea, Lowes $3 toilet Paper Roll spindles. I built the Toilet Roll adapters around these, you can print the one bearing adapter to confirm size. I printed the bearing adapters with a snug tolerence for the bearings and generous size on the toilet paper roller side. There is a bit of tension in the rollers. You should cut 2 rings off of each side of the spring, to shorten, and increase the fill rate, to 100%. The rollers place a lot of pressure on the blower head assembly, see picture of the temp in yellow PLA. This happened over a period of a couple of days. This was made for the Kolbalt 80v blower, To attach to a blower, you may want to use painters tape, duct tape, etc. I have since add a 4mm beam, across the center for bit of structural integrity. On my CR10Max show over 41hour print.
| Date published | 12/02/2020 |
| Time to do | 41 - minutes |