Tenax 3 Harness spreader

The harness spreader is intended to be used with a Woody Valley Tenax 3 harness. It is designed to be inserted between the leg loops of the harness to prevent the leg loops from pinching between the legs when landing.

Install by fitting the leg loops of the harness through the openings in the end of the harness spreader. Be sure not to twist the harness leg loops. Position the harness spreader just below your belt line so the leg loops rest against the inside of of your legs.

This item has not been tested. Use at your own risk. I take no responsibility for the use and installation of this item. The use of this item may cause death or injury.

additionally this item may cause a new found joy in landing your hang glider as you will no longer be getting pinched in a most uncomfortable area during flying and landing.

Happy flying. Enjoy.