Piggy Phone Stand / Keyring

Piggy Phone Stand
Version 2024

For horizontal or vertical placing of the phone (may not work for thick and heavy phones in vertical - try to resize smaller version for bigger phones for better stability)

There is also a Laying Piggy version (full Piggy model)
Versions with holes instead of eyes for 1.75mm filament (use 4-5mm of black filament)
Keyring addon (more about this below)
and Eyes addon to cover eyes holes or to be used in multicolor printer

Piggy Collection
https://cults3d.com/en/design-collections/c47/piggy

If you want to sell prints of this models (and much more) check: Piggy Set - Commercial license
https://cults3d.com/en/3d-model/gadget/piggy-set-commercial-license

You can also check my Phone Collection (some more designs for holding your phone)
https://cults3d.com/en/design-collections/c47/phone

Number on file names is thickness in mm of the space for a phone (6-16mm) - numbers are also on the bottom of models to show what size it is after print
Angle 16°

For resing phone models use the equasion:
'Needed space (in milimeters)' divided by 'model number' multiplied by 100% = 'Needed model size in percent'
For example if you need more stable 16mm you can take 10mm version resized to: 16 / 10 * 100% = 160%

To make a Keyring use a model of your choice and add there a keyring addon. Both models should be in the exact same position in your slicer to be sure that they will merge properly
Then select both models and merge them (right click menu)
Keyring models are with a 'frame', a flat surface that will not be printed. This way it is easy to set it in the right spot - Ignore model 'errors' and DO NOT try to 'fix' the model
After merging you can easly resize or rotate the model if needed

All models made in Blender 3D
Printed on Voron 0

Update 09 XI 2023
A lot of small improvements to the models - photos updated
It's more 'cute' , easier to print and files are smaller
See gif with two renders of Piggy Set for comparison

UPDATE 05 I 2024
Added versions for 6-9mm phones

UPDATE 04 IV 2024
Optimized models (around 50% smaller size, should look the same after print)
Added versions with holes instead of eyes to use with 1.75 filament - you can also use eyes addon to print the models in multicolor
Added numbers on the bottom to phone models to show what size it is after print
Added ‘mm’ to phone models to avoid rare confusions
Phone keyring addon improved a little

Printed with:
0.4mm nozzle
0.1mm layer height (you can try 0.2mm too)

Printed without infill (Prusa Slicer added inner bridge for support when needed)
2-3 walls
No supports needed