Nokta Makro Simplex+ Metal Detector Stand

Clamp on / Quick Release Metal Detector Stand that fits the NOKTA MAKRO SIMPLEX+.

• No screws needed ! See pictures for proper attachment location.

• Infill can be what you like however I haven't tested the stand for strength below 50% while using PLA PLUS filament.

How to attach stand to detector:

Squeeze legs, set in last slot under control arm, open legs and it pops into place.To detach from the detector , squeeze legs and slightly pull.

** UPDATE ! ** 3/11/20

Added a "lock" for the stand. It's not necessary unless your stand has a slightly loose fit to the detector.

• For strength print lock at 100 % infill.

• Push in center of stand to lock legs. You should have a tighter grip.

• To remove lock... push the back center with slight force while gently spreading legs of stand. (It's easier to remove lock and stand while the detector is flipped over in your lap.)

Notes:
PLEASE NOTE ! The spring tension isn't what holds the detector to the stand. It's the precise fitting in the slot that does. If you have a loose fit at the top please check to make sure your end is tightly pushed in and secure. There should be no gaps. This design is still under testing. If you have any issues or suggestions to make the print better please feel free to comment. Thanks ! -Glenn