FMP Mask Imalize security COVID-19 (Easy to print, no media, filter required)

FMP Mask Imalize security COVID-19 (Easy to print, no media, filter required)

Design offered by Imalize in solidarity to fight against the virus

Comfortable, ergonomic, sterilizable, N95 with filter, easy to print and durable

Ready to print with 3D printer 12cm*12cm*12cm

This model includes only the mask structure (2 pieces) but does not include the filter required to effectively filter the virus :

• We recommend the use of N95 or HEPA filters, Filter Mask Activated Carbon Filter Breathing Filters

To clean and kill the virus, we recommend one of the following steps every 3 hours in case of prolonged contact with an infected patient :

• Bleach or high-concentration alcohol

• Full dishwasher cycle (temperature drying included)

• Microwave at least 2 minutes

• Steam (minimum 10 min at 80°)

This model has not been approved by regulatory agencies. Use at your own risk

It was created and donated by Imalize to help people fight VIDOC-19

(Creative Commons License - Attribution - No commercial use - Share under the same conditions CC BY-NC-SA, registered design)

Mask FMP Imalize security COVID-19 (Easy-to-print, no support, filter required)

Ready to print with 3D Printer 4.7 "x4.7"

Comfortable, ergonomic, sterilizable, N95 2" Ready, easy to print and durable

This model only includes the mask structure (2 pieces) but does not include the required filter to effectively block the spread of the virus :

• We recommend to use N95 or HEPA filters, Filter mask Activated carbon filter Respiratory filters

For cleaning and killing the virus, we recommend one of the following steps every 3 hours in case of prolonged contact with an infected patient :

• Bleach or high concentration alcohol

• Dishwasher full cycle (temperature drying included)

• Microwave At least 2 minutes

• Steamproof (minimum of 10 min at 80 degree Celsius)

This model has not been approved by any regulatory agency. Use it at your own risk

It was created and offered by Imalize to help people fight COVID-19...

(Creative Commons License - Attribution - No Commercial Use - Sharing under the same conditions CC BY-NC-SA, deposited model)

Brackets: not necessary

Resolution: 0.25 mm

Filling: 35-40%.

Filament_material: ABS

Print Settings :

Supports: Not necessary

Resolution: 0.25 mm

Infill: 35-40%

Filament_material: ABS