Mage Knight organizers, Part 1: Statuettes + Crystals

Organizers for Mage Knight board game, Part 1: Statuettes + Crystals.

Part 1 set contains only:
04. Crystal organizer - 2 types.
06. Statuettes organizer - 2 types.

04 There are 2 types of crystal organizers. You can choose which one you prefer. The Crystal1 contains all crystal and mana dice. Its length is related to Day/Night board, so it can be placed near. The Crystal2 provides 2 crystal organizers for 2 sides of the table, so if there are more players, they all can easily reach for these components. In both types crystals in 4 colors are separated.

06 Statuettes organizer accommodates all hero miniatures, cities and Volkare. Each hero figurine and each city has a separate pocket. Volkar is much taller, so he lays down in his own section. The length and the width of this container are the same as of the enemy token stand, so they can be placed one on another in the game box.

In the new edition of Mage Knight bigger miniatures are present (since 2022, I think). I have adjusted the container to their sizes with Nazaroth help (thank you for the time spend on the measurements!). So there are 2 Statuettes organizers in the set: new and old. Old Statuettes organizer is the one on all my photos. Miniatures from editions before 2022 fit there (it was checked with edition with separate expansions and with first ultimate edition from 2019). New Statuettes organizer is higher and sections for Krang and Goldyx are bigger.

This is only a part of organizers for Mage Knight that I have prepared. There are available also "Part 2: Card trays", "Part 3: Hero organizers" and "Part 4: Enemies + Map tiles". Or you can also buy the whole set at one time - "Mage Knight organizers: The full set".

All organizers fit the game box and provide quick game setup. However it's not an insert.

Images in higher resolution on imgur:
Statuettes
Crystals1 photo 1
Crystals1 photo 2

General images of Mage Knight organizers:
The set, photo 1
The set, photo 2
Game set up 1
Game set up2
Packed

All organizers were 3Dprinted on PrusaMK3:
- in PLA,
- No support is needed.
- Infill - 10% rectilinear.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: 0.2 mmm layer height for Statuettes organizer speeds up the print (with 0.15 mm it's over 13 hours and with 0.2 mm it's over 10 hours)

Printing Time (for one organizer of each kind):
04.1 Crystal1: 5h40’
04.2 Crystal2: 3h21’ [2 pcs are required]
06a Old Statuettes organizer: 10h11’
06b New Statuettes organizer: 10h51'