Nexus Pro Demo Spigot (Shoot Nerf rockets from a Dart Zone Nexus Pro)

This model is a spigot that will fit into the front of the Adventure Force Nexus Pro, in place of the original muzzle piece. The inner diameter allows darts to be shot through as normal, and the outer surface will fit a Demolisher Rocket from Nerf.

To fit, after cleaning the print, press it into the muzzle block of the Nexus Pro.
To shoot rockets you should not have a dart in the barrel as that will prevent air from pushing the rocket properly.

I have found the ranges to be fairly short, 7-10meters, but it's a lot less bulk than carrying an entire demolisher/xbz/thunderblast/whatever to be able to shoot rockets.

There are 2 versions of the part, T and L, for Tight and Loose, these are slightly different tolerances as many 3d printers don't agree.
With either version I recommend lightly sanding the outside to prevent the layer lines from tearing the rocket.

Please be aware of the laws in your countries regarding toys like this, if you should print this in orange or some other colour as it's the muzzle piece.

I made a video describing this, and other parts, on my youtube channel here: [video was deleted]

I recommend printing upright, in the provided orientation, so that your brim or raft is at the back of the spigot, this makes it easier to cut away to fit it to the Nexus.

As this part is quite thin, 100% infill is recommended.