Car shelf supports for cars 1:43

English

How many times have you looked at your 1:43 scale cars and not sure where to place them?

With these simple pieces you will be able to obtain a minimalist and safe fixation to put all your collectibles jewels on the wall!

Materials and Specifications

The measurements of the board (preferably wood) to use as a base must be 16mm thick and 83mm deep, the length will depend on how many cars you want to place.

To fix them, make the holes in the wall with a 6mm drill bit, use 6x35mm dowels and fix the pieces with 4.5x40mm flat head screws.

It will only remain to observe his pieces looking on the wall on a safe and minimalist shelf :)

Enjoy them!

*** Cars not included, shown as an example ***

English

How many times have you looked at your 1:43 scale cars and not known where to put them?

With these simple pieces you can get a minimalist and secure fixture to put all your collectible jewels on the wall!

Materials and specifications

The measurements of the board (preferably wood) to use as a base should be 16mm thick and a depth of 83mm,the length will depend on how many cars you want to place.

To fix them make the holes in the wall with a 6mm drill bit,use 6x35mm plugs and fix the pieces with 4.5x40mm flat head screws.

All that's left to do is to look at your pieces on the wall on a safe and minimalist shelf :)

Enjoy!

Cars not included, shown as an example.

The best way to print the pieces is in the same orientation that is shown in the main photo, except for the central one, which is better to print lying to the side (a more resistant impression is achieved at that angle).

with a 25% infill, 3mm perimeters and 0.2 layer height is more than enough.

The best way to print the parts is in the same orientation as shown in the main photo, except for the middle one which is best printed lying on its side (a stronger print is achieved at that angle).

with a filling of 25%, perimeters of 3mm and layer height of 0.2 is more than enough.