MK23 Carbine DMR kit for AIRSOFT

EDIT NEW MODEL
https://cults3d.com/en/3d-model/various/mk23-carbine-kit-airsoft-advanced

This is by far my biggest design,
I wanted to design a customisable and modular Airsoft mk23 Carbine kit that could also be printed on smaller 3d printers.

This kit is printed in multiple segments and then attached together, I have found that the best way to join the models is in fact to use a 3d pen to "weld" them together as well as superglue but you could use epoxy or a glue gun, this allows the kit to be customisable for example you wanted a longer barrel you could just print more barrel sections and stick them together and the same with the picatinny rails.

The whole kit was printed on my Flashforge finder fitting within the maximum build volume of 14x14x14 cm so it can be printed on most printers with a larger print bed.

The print Features:
- mock suppressor with baffles
- modular
- customisable
- hole to allow access to a tdc if you have one installed
- can support no rails or can be covered in rails if you wish
- short cqb style stock that secures the rear of the kit in place
- can put a scope on a mk23

To assemble the kit you need to slide the mk23 into the piece that conforms to its bottom rail and the rest is up to you but feel free to contact me if you have any questions regarding this kit.

This kit is intended for use on airsoft guns only and should not be modified, it fits my stti mk23.

I cannot give any guarantees on the end result as it requires self assembly and there is of course always a difference between different printers and software used so the end product will always slightly vary in size shape and finish. Also I cannot give any statement on the durability or longevity of the kit as each one is different and so is its usage but if it breaks the advantage of this kit is the whole model does not need replacing only the broken section.

As for the joining of the prints most joins have channels between them to enhance the surface contact area and thus the strength of the join but that depends on the print and adhesive used and there are some areas for bolts including the slide catch, these are included but not required as this kit is modular to your needs.

just to be clear this is the purchase of the carbine kit only, no replica firearms included and the accessories shown were for illustration only. I hope you enjoy this product

ozziedesigns

-This kit contains multiple smaller models to print and then join together.
- I printed this in PLA with 4 perimeter shells, 4 bottom and top shells in the orientations the files will come in with supports and brims to minimize warping all at 195 Celsius with 15% infill but i accept other printers have different capabilities, settings, software and usable material so results will vary