3 shelf supports (Ipad) (shelf support)

Update 29/11/2020 New Ipad pro support with less inclination ( 21° and 46°). see comparative photo.

This is a strong support that allows you to have a good angle to use the shelf on a coffee table (tilt 21°) and the other way around to use it on a table (tilt 66°).

In addition is light and resistant.

two versions in inclination ( 21° and 66°) for my iPad pro with its 12mm thick protection and a 6mm flange and the other one for normal iPad but which has a very big protection of 18.5mm and a 15mm flange.

(if someone needs a specific size, please ask me)

to avoid as much as possible the supports print it on the edge.

Post your 3D prints, it's always a pleasure ;)

Don't forget to subscribe to get the updates.

Update 11/29/2020 New Ipad pro support with less incline ( 21° and 46°). see comparative photo.

This is a strong support that allows a good angle to use the shelf on a low table (21° tilt) and the other way to use it on a table (66° tilt).

In addition is lightweight and resistant.

two tilt versions ( 21° and 66°) for my iPad pro with its 12mm thick protection and a 6mm edge and the other for normal iPad but which has a very big protection of 18.5mm and a 15mm edge.

(if someone needs a specific size please feel free to ask)

to avoid as much as possible the supports print it on the slice.

Post your makes, it's always nice ;)

Don't forget to subscribe to get updates.

12x6 (in medium)

Printing time: 12 hours 9 minutes

Filament length: 51121.2 mm

Plastic weight: 153.70 g (0.34 lb)

Cost of material: 3.07

18.5x15 (in medium)

Printing time: 15 hours 15 minutes

Filament length: 67980.7 mm

Plastic weight: 204.39 g (0.45 lb)

Cost of material: 4.09