Bedroom Lamp

Hi, I designed this lamp (which is really cool xD) for the #FLASHFORGECULTS contest, you can combine it as you want and to the environment you want :)

Easy to print and easy to assemble.

Necessary materials:

• 4 M3x12mm screws

• Led strip ( In my case NOT RGB)

• DC Male + Female Connector

*https://www.amazon.es/dp/B01LZBWAT5/ref=cm_sw_em_r_mt_dp_cDPMFbX1M62GT

*https://www.amazon.es/dp/B01AQ33ELM/ref=cm_sw_em_r_mt_dp_FHPMFbEEHWDCD This led strip, is an example, I bought it in a big DIY store near my area.

ASSEMBLY

*You introduce the strip of led, you cut it to the measure and where it indicates the own strip of led, you put the lids that cover the strip of led with a few drops of cyanoacrylate (Glue). Then you join the body with the base cover, for also a little glue for more security ( EYE careful with the orientation, the lamp has to look at the opposite of the hole of the base cover where the DC connector goes, once fixed the body with the base, put the pin, it is the second insurance that if it does not move, the first was the glue with the base. Now all that remains is to make the connection of the cable with the DC female connector and place the cover with the 4 M3x12 screws.

The DC connection is simple, the two wires of the led strip, are connected to the female of the DC connector and on the other side of the cable to the male of the DC connector, very simple.

If you like it don't forget to give it like and for any question, don't hesitate to leave me a message.

Print and enjoy!

#FLASHFORGECULTS

I will leave the printing parameters for each piece, except for the material and speed section, which will depend on the material you use and your machine. In my case everything was printed on a Prusa i3MKS.

Body

*Hood height 0.3 / Filling 20% / Perimeter 4 / SI support

Base - Base cover

*Hood height 0.3 / Fill 20% / Perimeter 4

Led1 Cover - Led2 Cover

*Hood height 0.2 / Fill 30% / Perimeter 3

Pin

*Layer height 0.1 / Filling 100% / Perimeter 4 / Edge