Nintendo DS Replacement Stylus
Nintendo DS Replacement Stylus
Published 2020-11-18T13:50:34+00:00
This is a Stylus for the Original Nintendo DS. Surprisingly hard to find decent replacements for them, so I made this.
Rounded nose to minimize scratching (no clue if it does but not having a point does help).
Print the model as is, so you can also include the little dimple without supports.
Shouldn't require any post processing but if you'd like you can sand it.
If you don't have a 3D Printer I can make it for you from my stores on eBay and etsy
etsy - http://www.16bitgamestore.etsy.com/
eBay - https://www.ebay.ca/usr/16bitvideogamestore
Requires a raft.
The Model is designed to be printed as is, and it should be printed on it's side, so rotate it 90 Degrees until it's flat and check the first layer so it's a line with a dot.
100% infill isn't necessary but it does feel nicer.
0.2mm layer heights can be used, but 0.1mm layer heights feel the nicest
Date published | 18/11/2020 |
Time to do | 25 - 40 minutes |
Material Quantity | 1.09g |
Dimensions | 75.37mmx7mmx4mm |