Zen Lamp Bedroom Ceiling Lamp

Hello! Well this is a lamp for the ceiling of a room or an entrance. It is printed in 3 stages to achieve dimensions of 40x40 ideal for a bedroom and you can alternate colors to make it look good with your bedroom decor,

Phase 1: X1 central square measures 20x20

Phase 2. X4 end prints that then easily attach to each other and to the center square (Note: Select "none" in "adherence to the printing plate" as if you put skirt on it is possible that the print will not go in.

Phase3: X2 lamp holder and oculi. They attach to each other so they can then be screwed to the ceiling and hold the lamp.

It is an easy design to print..without supports (except for a small and necessary one in the squares at the ends) and it looks really nice. I hope you like it. :D Best regards!

Important Note1: I used gu10 led bulbs that I had at home to avoid excessive heat.

Important Note2: I have not used crystals, I used transparent plastic from a 1 euro folder bought in the Chinese and cut with scissors, it looks like glass! (Attached photo) I would have liked to try transparent filament but I did not have :(

If you like this model I will be very grateful with your support 👍!

Let me know if you like it, if you print one yourself (maybe upload a photo..), and you can also check out the other things I do on my profile. I'm still learning how to design, but I have lots of ideas and a desire to keep improving.

If you want to give me some advice, I'd really appreciate it, I'll think about continuing to do these things because I'll know that I will

someone likes my design!

Printer: Ender 3pro.

Material used: PLA gray PLA white

nozzle 0.4

Layer height:0.2

Impression speed 50 Movement speed 150 Filling 30%.