Open bed and table book holder

If you like to read you have to have it. There are two bookends, one to be used on the bed with 4 hooks, 2 to hold the book open and 2 to hold the pages. The hooks can be moved so that they do not disturb the reading. The second stand is a table stand which is made to place the first stand with the book inside. The table stand can also be used to hold an open book.

The holders are made to fit any book on the market.

Feet:

• 2 side boards plus middle hinge that are joined with 2 rods that carry a cap each so that it does not come out ( you have to pay ).

  • 2 hooks for each board ( to hold the book ) that are mounted on the guides below.
  • 2 hooks for each board (to hold the pages) that go on the guides above.
  • 4 guide covers to be mounted so that the hooks do not come out of the guides.

Written in the name of the files how many times you have to print (the same number of times and you need more than one).

Take a look at the Patreon profile:

https://patreon.com/CreativeDesigns988?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=creatorshare_creator&utm_content=join_link

Layer height at most 0.2 if you use 0.4 nozzle.

The 2 boards and the middle hinge :

Filling at least 50% ( if


is 100% better )


The flat part of the feet goes to the


hot bed and put support by touching


hot bed.

Hinge rods :

100% filling and support by touching the


warm bed

Hooks, guide covers, rod covers :

No need for brackets and little padding

10%....20%...it depends on each one how much

material can be spent.

Table stand:

No supports and at least 40% of


filling.