Hand on duplo-compatible block

Made the hand much smaller and put it on top of a duplo-compatible 2x2 block. Update: There are three versions: (1) hand is a bit embedded in a Duplo-compatible block, (2) hand sits on top of a Duplo compatible block. Also added a 2x2 Duplo block. (3) A Lego-compatible version.

I find it a nice object for testing g-code generators for the RapMan (skeinforge and Netfab engine for RapMan). The code must deal with an overhang and small fingers.
Of course, can be used to play with any other software/3D printer combo. See http://www.thingiverse.com/thing:2714 for this.

Additional credits: Domonoky ( thingiverse.com/thing:1778 ).

If you want to create your own, get a Duplo-compatible block, e.g. take the one attached or make it from my doblo factory ( http://www.thingiverse.com/thing:2106 )
Then get the original hand, make it smaller, position/merge the two. E.g. with OpenScad or with Netfabb Studio/Meshlab, or with Netfabb pro.

Print parameters for the DUPLO compatible blocks (doblo) you can see in the picture with only two yellow hands (skeinforge to the left, Netfabb to the right). These are better quality, removing the strings was easy. Netfabb can (not yet) deal well with the large overhang in the DUPLO floor.

Filament: PLA translucid yellow from BFB

Netfabb engine for RapMan:
* Print time = 71 minutes
* Calibration was done in one shot (I took the almost minimal values)
* Quality setting = low

Skeinforge
* Print time = 64 minutes
* Layer Thickness = 0.35
* Clip Over Perimeter Width = 0.15
* Cool Type = Orbit
* Min Layer time = 1
* Extra shells on Base = 2
* Infill perimeter Overlap
* Infill solidity = 0.3
* Solid surface layers = 4
* Jitter = activated
* Temperature = 210 for ALL
* Flow Rate = 250
* Feed Rate = 16

Print parameters for the Duplo-compatible red hand in the first picture
* Filament = ABS
* Layer thickness = 0.4
* Flow rate = can\'t remember (probably around 450, i.e. too much)

PLA Skeinforge Print parameter variations for the Lego-compatible block (lugo-handx.stl). This one is tough to print. Hand comes out not to bad. I am less happy with the Lego 2x2 brick.

• Layer thickness = 0.25
• Feed rate (Speed) = 16
• Flow rate setting = 130

For better quality, speed/flow rate should be lower.