PLAYSTATION 5 PS5 CONTROL PAD AND HEADSET WALL MOUNTED HOLDER

**Wall mountable PlayStation 5 dual and single control pad and headset holders. These are the skeleton supportless versions that use up less filament and require no supports.

**Contains 2 files;
1x PS5 wall mounted single control pad and headset holder.
1x PS5 wall mounted two control pads and headset holder.

**You can either use double sided tape or small tack nails to wall mount them.

**Specifications for single control pad and headset holder.

Size: 50mm x 160mm x 75mm,
Print weight on Cura using the settings stated below: approximately 88 grams,
And Cura print time (Ender 5 Plus 40mm/s): approximately 12 hours and 47 minutes.

**Settings (Cura 4.7 using an Creality Ender 5 Plus):
Nozzle size: 0.4
Layer height: 0.2
Initial layer height: 0.2
Wall thickness: 1.6
Wall line count: 4
Top/Bottom thickness: 0.8
Top thickness: 0.8
Top layers: 0
Bottom thickness: 0.8
Bottom layers: 999999
Horizontal expansion: 0
Infill density: 100 (I haven't tried less infill than this. It all depends on your filament strength)
Infill pattern: Cubic
Build plate adhesion type: Brim
Generate support: No

**Specifications for two control pads and headset holder.

Size: 50mm x 270mm x 75mm,
Print weight on Cura using the settings stated below: approximately 122 grams,
And Cura print time (Ender 5 Plus 40mm/s): approximately 17 hours and 48 minutes.

**Settings (Cura 4.7 using an Creality Ender 5 Plus):
Nozzle size: 0.4
Layer height: 0.2
Initial layer height: 0.2
Wall thickness: 1.6
Wall line count: 4
Top/Bottom thickness: 0.8
Top thickness: 0.8
Top layers: 0
Bottom thickness: 0.8
Bottom layers: 999999
Horizontal expansion: 0
Infill density: 100 (I haven't tried less infill than this. It all depends on your filament strength)
Infill pattern: Cubic
Build plate adhesion type: Brim
Generate support: No