Hanger Clamps for 4" Outlet 7.8" Diameter Carbon Filter For Indoor Garden / Air Filtration System

These clamps are designed to fit a carbon filter with an outer diameter of 7.8". These types of filters usually feature a 4" intake/outlet flange, and are often used in indoor gardens, and airbrushing fume hoods. They feature a small flat foot on one side to aid in aligning the rings before tightening things down.

These Clamps work best on filters that use a pre-filter over the perforated metal outer casing. If you do not use a pre-filter (you should), you can glue on a few strips of craft foam or craft felt to the inside of the rings to take up the small amount of gap.

Fits this type of filter: 4 Inch Air Carbon Filter

Which is also found in this kit.

Uses M3x3mm knurled brass heat-set inserts found here.

Uses 1 M3x6mm screw found in this kit.

*Note: This post contains Amazon Affiliate links that support The Makers Workbench via a small commission from any sales they help generate.

I charge for files because I am a professional content creator and do this for a living. I feel that I price my designs fairly and on-par with my fellow creators.

Design Zip File includes: .stl .f3d, step, and obj files. Sketchup files are also included where applicable.

Follow The Makers Workbench on:

• Instagram
• YouTube
• LBRY
• TheMakersWorkbench.com

I have only tested this model using the default 0.20mm Linear Advance preset in Prusa Slic3r 2.2.0 with the following amendments made.

• 8-perimeters
• 5-top layers
• 5-bottom layers
• 20% infill
• Gyroid Infill
• Concentric Top and Bottom Pattern

Print time on a stock Prusa i3 MK2s is about 2-hours 32-minutes and uses an estimated 61.81-grams of PLA filament.

PLA Used: Polymaker Polylite PLA