Airsoft Vz61 skorpion AEP upgrade set

Hello everyone!, I designed this tweaks set for the Vz61 electric version.
Based on the model from ASG, it will work in any skorpion AEP such as JG or Well.

WHAT IT CONTAINS:
It contains a sling mount for ~25mm straps, an extremely low profile T1 Mount, a short 14mm CCW suppressor adapter, a muzzle device and a model for a replacement grip bottom cap

ASSEMBLY:
MOUNTING THE SUPPRESSOR ADAPTER
- Twist counter-clockwise until you feel it tightening.
you dont want to over-tighten the adapter because it might break during installation or removal.
Same goes for the muzzle device.
ASSEMBLING THE T1 MOUNT (2x M3*10-12mm required)
- To assemble the T1 mount you first have to join up the T1 with the mount using 2 of the original T1 mounting screws (countersunk m3) inserting them in the countersunk holes.
now that the red dot and the mount are joined, remove the old rear sight from the upper reciever of your vz61.
Insert 2x M3*10-12mm screws trough the rear sight holes and the mount, screwing them in the T1.
Now use one of the remaining T1 mounting screws to further secure the mount in place, inserting it in the middle hole of the rear sight and tightening the mount in place.
ASSEBLING THE SLING MOUNT (1x M3-25mm required)
-To assemble the sling mount you need to insert the m3 screw in the hole and start screwing a bit to hold it in place.
Slide the mount over the round side of the barrel at the preferred rotation and tighten to secure it in place.
ASSEMBLING THE GRIP PLATE (1x 3-4mm diameter spring; 2x 2-2.5mm Plastic Screws or M2.5)
-To assemble the grip plate you need to slide the lug inside the slot on the main body, insert the spring and then screw the bottom plate on top of the exposed spring to prevent it flying out.

Layer Height - 0.1

Material - PLA, PLA+

Wall count - 4

Infill - 60

Layer adhesion - Brim

Printer - Anycubic Mega S