Height adjustable magnetic Dagoma table top support

Removable system, designed for the mounting of a glass plate but also possible on any other plate.

Magnetic system with a magnet integrated in each support and a magnet integrated in each block glued under the tray.

Important: A pause must be allowed when printing each support to insert the magnet during the print and a pause when printing each pad to be glued to insert the magnet during the print.

Adjust the position of the pavers before gluing them so that they fit perfectly into the finished assembly.

Height adjustment is carried out by means of the screws to be inserted into the tray supports. Insert lock nuts so that the adjustment does not shift due to vibrations. There is an inner and outer slot to lock the screw.

The system works by an inclined plane pushed by the screw to raise the stud that supports the tray.

Tensioning of the platen is carried out with the belt clamps directly on the carriages.

SHIFT: Modification of the belt tightening cover, reinforced version added "reinforced belt tightening.stl" to be used instead of "belt tightening cover.stl". Allows to avoid the deformation of the part and ensures a better holding of the belt.

• 4 magnets diameter 18 mm, height 5mm. ( in LM DIY stores )

• screw 3*12 ( 8 )

• screw 3* 20 ( 4 )

• brake nuts M3 ( 16 )

Height adjustment bisot X4

X4 height adjustment

Pave magnet X2

Clamping cover X2

Platform trolley X2

Support plate X2