Takanashi Kiara and her employees
Takanashi Kiara and her employees
3D
Published 2021-02-04T11:31:50+00:00
Update 24 Apr 2021: To make sure this is actually Tenchou, I add her 2 hats (named red and chef) with a ribbon. Print them without support. Print ribbon vertically to make sure layer line is not an issue. Coat and paint and coat again like all parts. I also upload a photo of her wearing the two hats with ribbon as a prove that it is printable.
Disclaimer: This is a fan project. No commercial.
Started in September 12th, 2020, Kiara the Phoenix debut on Youtube as a Vtuber under CoverCorp's Hololive EN - Holomyth theme. One of her goal is to open a fastfood chain to rival the biggest names in the world, and therefore KFP was born. It is not a cult.
Kiara, the boss of KFP, stream almost everyday. She's one of the hardest working streamer in the Hololive EN. She's energetic and friendly and relatable in many ways. The unique thing about her stream is that she can speak 3 languages, English, German, Japanese, fluently, complete with that word confusion all we multilingual have. She's also very active on Twitter.
I joined the KFP crew as an egg somewhere in December. I brought upon myself the duty of KFP - Sticky Note Service, mostly remind the boss of something she needs reminding. I can't draw very well. I work and live in a country that superchat is not available. So, this is one of a few ways I can contribute to KFP.
Glory to KFP
Viva la Kiara
Credit:
Kiara model is made by VampirkoO on Sketchfab under CC-NC license. The model was not suitable for 3D print, so I repair it to make sure it will print.
The KFP logo is from kiarafriedphoenix.com. I have no idea who register that website, but I salute you. O7
The "employee" or the chick is a model from Microsoft 3D Builder library. It's called Chicken in Egg.
The base is simply a cut out to place the models.
The most difficult print is the Kiara herself. The legs in particular. I align her model in such a way that easiest to print with minimal support required. There are a few points to consider when printing her.
- Make sure her nails stick to the bed. That place is the most troublesome.
- If you put manual support, or even with auto support, make sure the legs are support even when your printer can do the angle without one. This is important because the leg is small and as it prints there is a high chance that it will wobble. You can have layer shifts on the leg very easily. With support under the leg, it adds more mass and stability to the leg and prevent such problem.
- KFP logo will have one bit of flame detached. It should be glued back in at that position. If it doesn't detach itself, you may have quite an elephant foot. In that case, you don't really need glue.
| Date published | 04/02/2021 |
| Time to do | 47 - 750 minutes |
| Material Quantity | 90g |
| Dimensions | 120x120x90 |