Google Pixel 3 Earphone Case

This is a little magnetic box for the google pixel 3 earphones designed in Blender 2.80.

You will need six 5mmx2mm (diameter x height) magnets to complete this project.
The box is the size of a credit card with an height of 2.5 cm.

I have tried to make the smallest box possible that allow you to display your earphones with style but also to hide the cable. I might have been too far on the small side for this one and you have to wind up your cable tighty. Also, the amount of place for the volume buttons is really not big so you will have to be carefull when putting your earphones in this box in order to protect the connections betweens the cable itself, the usb-C connector and the volume buttons. Keep in mind that these connections should not be bend with an hard angle if you want to keep your earphones for a long time (this is the reason why I should have make this slightly bigger but as I say, I wanted the smallest box possible, any remix is more than welcome!).

Also you might need to clean lightly the plug for the neodym magnet (5mm diameter x 2mm height) to press fit the magnets in place, particularly on the ones that will print vertically.

I have print the two part at the same time and it took roughtly 5 hours and a half.

The box should be able to stand on all its sides.

I am doing my best to produce good looking and reliable designs so if you feel like it you can offer me some coffee by tipping me :)