MWR Designs - Landy Mixed Mods

A collection of mixed mods for the 3dSets Landy 3,4 and 5.
From an American Format plate holder to a suspension lift kit, You might find exactly what you need in this collection.

Visual Mods

-American Plate Mount
-Light Bleed Covers
When using LEDs you might end up with light bleeding into the wheel wells, This part will help eliminate that
-LED Sockets
These Simple light sockets allows mounting 4x 5mm + 2X 3mm LEDs in the Front and 4x 5mm + 2X 3mm LEDs in the rear

Lift Kit

-Front TrackBar Extended
-TrackBar mount Remix
A longer mount that is extended and much stronger than the original
-Control Arms Extended 5mm
Lighting the truck 10mm allows for some longer control arms and looks better with a slightly longer wheel base
-Suspension Offset 10mm
You can keep the original 90mm Springs. These brackets lower the top mount point by 10mm.

Remixes

-Cardan Yoke Remix
This remix allows for spacing adjustment to align the steering knuckle and yoke distance perfectly
-Cardan Cross Remix
removes the holes from the print but leaves small center punches to drill after printing with a 2mm bit. This helps the cross print more durably in my experience.
-Servo Offset 10mm
Offsetting the Servo forward 10 cm allows the front suspension to fully compress. For this mod you need to use the Bumper mount remix
-Wheel Shafts M4 Remix
Use this mod to convert the front and rear axles to M4 studs instead of M3 screws. You'll need M4 threaded Rods cut to length for the rear and 2x 25mm screws for the front
-Bumper Mount Remix and 6mm Extended
-Wheel Spacer 12mm to 8mm Disc Brake

All parts can be printed 100% infill as they are pretty thin. No supports needed for anything in this kit. All STLs come preoriented and grouped for easy printing.