Smartphone holder for automotive fans

English

If you are an engine lover, you cannot miss this beautiful holder for your mobile phone on your desk divided into parts for easy printing and choice of colors.

The download consists of 5 files in STL format ready to be printed by FDM or SLA.

For the optional finishing of the presentation you will need a 6mm wide tape of the fabric you want and a little glue or hot silicone and its assembly is very easy:

Clone the "Side hitch" file 4 times to get all 4 side anchors.

Insert the extinguisher in the tab enabled on the roll bars, then insert the chair into the tabs of the roll bars and finally cut the belts to the size you want (6mm tape) surround the area where it will be fixed and use just a drop of glue to close the tie, use the same method for the belt anchors.

Enjoy it!

English

If you are a motor lover you can not miss this beautiful holder for your mobile phone on your desk divided into parts for easy printing and choice of colors.

The download consists of 5 files in STL format ready to be printed by FDM or SLA.

For the optional finishing of the presentation you will need tape of the fabric of your choice 6mm wide and some glue or hot silicone and assembly is very easy:

Clone the "Side hitch" file 4 times to get the 4 side anchors.

Insert the fire extinguisher into the tab on the roll bars, then insert the seat into the tabs on the roll bars and finally cut the belts to size (6mm tape) around the area where it will be fixed and use just a drop of glue to close the tie, use the same method for the belt anchors.

Enjoy!

Can use 0.2 layer height, 15% infill 2mm perimeters and activated supports

Can use 0.2 layer height, 15% infill 2mm perimeters and activated supports