Ender 5 Plus 360 Degree LED Strip Mount

https://youtu.be/T3unk0VuqfI - Articulating Robot (https://www.thingiverse.com/thing:1134277)

Here is a Ender 5 Plus 360 Degree LED Mount that I designed. I wanted to utilize the entire LED Strip that I purchased, rather than cutting it short and wasting it. I purchased a 16.4ft (5 meters) LED Light Strip (https://www.amazon.ca/gp/product/B07TS7L62W/). You can use any LED light strip you want, but I found that the length of this one was good to give around 3 entire rows of lights. These ones are great too if you use OctoPrint, as you can get the IFTTT plugin and then turn the lights on/off when your prints start/end.

I printed this in PLA, so I added some aluminum tape on the PLA just to give it a little more protection in case the LED strip generated a bunch of heat (which I probably was ok..).

These connect to the frame in the corner with 3 M3*20 screws and nuts. They barely fit, so if you have longer ones, you can use those.

The back right corner does not have a screw as the end stop is there, but the back right corner is designed to sit on top of the bracket and has a cutout for the end stop cable.

EDIT: Added different variants for the joinbars depending on how calibrated your printer is. Print out the JoinBarMeasuringTool and then use to see which one of these JoinBars to use.

EDIT2: Added a taller version that actually lines up to the front and back edges of the 2020extrusions. Also included longer joinbars for that reason.

I printed these without supports and orientated standing on one of the ends. The dovetail that is on the plate should be able to bridge without issues and the one that is standing up will not need any help. I used Cura to block all areas where supports would be needed. Also wouldn't hurt to put in AntiWarp tabs.

-