BIG BORE HIGH POWER AIRGUN SILENCER CALIBER .30 / .357 / .50

BIG BORE HIGH POWER AIRGUN SILENCER CALIBER .30 / .357 / .50

This new silencer is made on demand from the big bore airgun owners!

THIS IS THE CALIBER .30” / 7,62 mm.

Also available in caliber .357” and .50” = 9 mm and 12,7 mm.

All silencers have a M18x1 thread carefully designed and repeatedly tested to make a perfect fit maintaining parallel mounting time after time. The outer diameter of the silencers is slightly bigger – 50 mm, managing even larger air volumes. The length is 260 mm.

Based on the popular shockwave design this new silencer is designed to withstand the higher pressures and larger air volumes from high kinetic energy/velocity airguns.

These silencers are equipped with lamel reinforcements making them much more resistant to high pressure and rough handling / drops on the floor. The shell and baffles are also thicker ensuring durability.

A threaded hexnut M18x1 is included in the package. Use it as an end stop on the barrel or as a thread calibration tool. If the hexnut is too tight on your barrel or adapter scale it up 1-2%, reprint and test. If the hexnut is too loose on your barrel or adapter scale it down 1-2%, reprint and test. Then print the silencer relative the hexnuts scale.

The inner hole / trajectory is slightly cone shaped that ensures no impacts while maintaining tight tolerances. These big bore silencers have a relative bigger inner hole than my smaller caliber silencers because of the more violent recoil that often causes barrel rise and changing the trajectory, see the specific dimensions in the drawings.

Available in calibers:
.30” / 7,62 mm
.375” / 9 mm
.50” / 12,7 mm

Lengths and diameters:
260 mm x 50 mm

For best results when 3D-printning:

• Use a brim for increased build plate adhesion and stability!
• Use a layer height of 0,1 mm.
• Set the printerhead velocity to maximum 40 mm/sec, for decreased vibrations.
• Suitable printing materials: PLA tough or regular PLA.
• The silencer must be printed with the exit hole downwards and the threads up.
• DO NOT USE SUPPORTS, the overhang is maximum 40 degrees.