loopy loop 3-way

Simple and fun, easy to print, easily customizable!

Loopy loop with 3 paths that meet in 1 at the top.

By tilting the loopy loop we can choose which tube to drop the ball into. If the ball falls next to the tubes, it is stabilized between 2 tubes, and with a small stroke of the wrist you have to make it fall back into the tube and resume the game!

To count the points and this launched challenges between friends:

-Fell directly into the central tube => 3 points

-Fell directly into a side tube => 5 points

-Dropped into a tube in 1 handstroke => 2 points

-Put back in a tube in 2 strokes => 1 point

-Put back in a tube in 3 strokes => 0 point

-Put back in a tube in 4 grip stroke => -1 point

-Put back in a tube in 5 stroke => -2 points

etc..

-Ball dropped on the ground => -3 points

https://www.youtube.com/watch?v=VesJjTugZJs&t=16s

Print on Anycubic Photon Mono .

Put a raft + lots of support at the base.

Resin Resione watter washable W90B.

Exposure time 2,2s

Bottom 50 sec / 6 layers

Print height 0.05

Printing time : ~3h30

Ball used : Steel Ø10mm

Ball in 3D files hollowed out, it is necessary to print 2 shells and placed a steel ball Ø6mm inside to avoid bouncing. Failing that, use sand.

Full ball in the 3D files in case you don't have any ball or sand at home or if you are looking to increase the difficulty :-)