Yeah lamp + Gyver lamp remix

This lamp based on wave lamp yeah and russion rgb lamp project caled Gyver lamp.
Software guide and Gyver lamp project link : https://alexgyver.ru/gyverlamp/
Shade remade as cylinder for smoother led translucency.
To attach led stand to base i use m3x4x4 brass nuts. Controller just pushed to the gap and screwed with m3 bolts esp chip down.
In my project i use 60 leds per metr ws2812b led strip cut by 11leds per piece and glued to led stand vrticaly (16strips totaly). Leds powered directly from controller pin UV (not al models of node mcu have this one). Warning 11X16 matrix with white light on max brightness consumes ~50w, controller pcb and most of usb chargers are not designed for such curent. If you want to use maximum brightness use power connection as described in original gyver lamp project. My project is made in the main for fire efect and it enough
10-12W mobile charger.
Filament PLA
Print settings
Shade -upside down, vase mode, 0.2 mm layer , beter with 5 botom layers
Base , thread , led stand - no supports needed

Glue the thread ring to the shade and screw it to base.

Files include 2 types of base for different sizes of node mcu controller (25.5x48.4mm and 30.4x57mm) , and 2 types of led stand: fully printable and 50mm tube adapter.

-