Sink drain flange / sink drain flange

Ideal for broken plastic sink lids where trash or other objects are leaking out.

It is recommended to print on ABS:

*Extruder temperature: 240°C

Bed temperature: 100°C

The use of a printing support is not necessary, it is also recommended to use the "Fixing" function in CURA.

When printing, set the bed temperature to 100 °C and the extruder temperature to 240°C and preheat the ABS, spray the bed with lacquer or similar and start printing.

Approximate run time, for 20% fill and 0.2 resolution: 56 minutes

The grid applies for a 2" pipe, equally the broken grid hole is smaller, you can Remix for your measurements through tinkercad or preferred printing software.

Ideal for broken plastic basin lids where garbage or other objects escape.

It is recommended to print in ABS:

• Extruder temperature: 240 ° C

Bed temperature: 100 ° C

It is not necessary to use printing media, it is also recommended to use the "Fixation" function in CURA.

When printing, set the bed temperature to 100 ° C and the extruder temperature to 240 ° C and preheat the ABS, spray the bed with lacquer or similar and start printing.

Approximate execution time, for 20% fill and a resolution of 0.2: 56 minutes

The grid applies to a 2" spout, also the hole of the broken grid is smaller, you can Remix for your measurements through tinkercad or preferred printing software.

-