Anubis shrine deckbox for Magic The Gathering 3D print model

This is my Magic: The Gathering deckbox. I made it spesifically for Amonkhet and based it off of the Anubis shrine from ancient egypt. This design should fit 3 60 card decks (hopefully sleeved, but haven't tested that at the moment) pluss a die or two and other small accessories. There are 3 main parts: the chest, the top and Anubis. Anubis' tail is cut of the body so it's easier to print without a lot of support. The 3 parts are held together with magnets. This makes it easy to remove anubis when traveling, and attatch him again at home so it looks good at the shelf. The magnets i used are 8.85 mm diameter and 3 mm high.

The tray for the dice on the model in the picture was to small so I changed that in the uploaded files. Your version will have bigger tray so i hope the dice fit in.

If you want some changes to the model, like holes for other magnets or another inside, just send me a message about it and i will fix alternative versions of the model. Also if there is somehing wrong with the model, or something you dislike, do not hesitate to send me a message.

Hope you enjoy printing your own egytian deckbox!