Wall-mounted Siva Logo Lamp

Please download my models via Printables :)
https://www.printables.com/de/model/162884-wall-mounted-siva-logo-lamp

This wall mounted Siva logo lamp is my contribution to Season of the Plague. For more information on the fan project and a ton of amazing siva themed stuff visit the official Season of the Plague twitter account: https://twitter.com/SeasonThePlague

What you need to make your own lamp:

• A good amount of black filament for the front and back shell

• Some transparent red filament for the diffusor

• One of these battery powered LED strips: https://www.amazon.de/dp/B08FDTF88D/ref=cm_sw_r_tw_dp_Z4M1CTPGGB24K7EFJWCX

• Aluminium foil or reflective tape

• Glue or tape of your choice

• Two (at least) 50mm long Nails with a head diameter of less than 9mm

How to print the parts:

• Diffusor
  Rotate the model in your slicer so it is flat against the print surface and print it solid

• Front shell
  Rotate so the logo is facing the print surface and print solid as well

• Back shell
  Rotate so the holes for the nails are facing the print surface and print with about 10% infill
  This model does not need any supports, bridging is your friend here!

Assembly:

• With the glue/tape of your choice stick the diffusor to the back of the front shell

• Stick a good amount of aluminium foil or reflective tape to the top side of the back shell to reflect the light from the LEDs

• Guide the LED strip through the hole in the back shell and stick it to the top side wall in a circle

• Stick the LED strip's battery pack to the wall-facing side of the back shell

• Slide the front shell over the back shell

Notes:

• The holes for the nails are 90mm apart

• When putting the nails into your wall, make sure to let them stick out a bit so you can use the push button on the battery pack to turn the lamp on or off by pressing the whole thing against the wall a little

-