Dwergar organizers

Organizers for Dwergar board game. All organizers fit the game box and provide quick game setup. Comfort during the play is the priority in this design. Organizers are decorated with theme ornaments to highlight the game atmosphere.

The set contains: Resources organizer, 4 Dwarf chests, 2 Card trays with Card separator and Token organizer.
01. RESOURCES ORGANIZER has 4 sections shaped and decorated as train cars. Each section has rounded bottom to facilitate item draw. A lid is provided to prevent rocks from falling out of the container. The lid is attached to the container by a screw.
I've designed 2 small and 2 bigger sections as in my game there is strong diversity in size and amount of rocks. So in smaller sections I keep Crystals and Irons. If you'll have problems with fitting rocks from your set in the container, please, let me know. I can make some corrections, e.g. make the container higher.
02. DWARF CHEST is assembled of a container and a lid + crystal. There's a different chest for each player - they vary in ornaments. All decorations are theme related. There's a recess in the top of each lid, where the Crystal comes. The Crystal can be printed in 4 colors: red, green, blue and yellow. Then it should be glued into the recess. All 1 player's items are kept in one chest: Heat level marker, Foreman meeple, Victory point marker and Furnace tokens.
03. EVENT CARD TRAY is my standard card tray with sloped bottom and indentation that facilitates card draw. It is customized for Event Card deck. It was designed for cards without sleeves + one Card separator. The Card separator is used during the play to separate chosen 9 cards from the rest of the deck.
04. PROJECT CARD TRAY is my standard card tray with sloped bottom and indentation that facilitates card draw. It is customized for Project Card deck. It was designed for cards without sleeves + 4 Card separators. 4 Card separators divide 5 decks (blue, green, gold, black and red seals) during the storage.
05. CARD SEPARATOR helps to divide different decks. I use 5 card separators (as described above). It is wider than cards, so each deck is easy to pick up. The separator is decorated with theme reliefs.
06. TOKEN ORGANIZER accommodates Resource Multiplier Tokens and Deck Advantage Tokens + Silverbeard Token. They are kept in 4 thoroughly designed sections with sloped bottom and indentations to facilitate item draw. It is kept in vertical position during the storage, so it fits game box very well. While during the play it is positioned horizontally to facilitate item draw.

Note1: I keep Worker meeples in a textile bag, so the random draw is simpler. I use 10x14 cm bag.

Some photos in higher resolution:
The set
Game set up
Resources organizer 1
Resources organizer 2
Dwarf chests
Packed

All organizers were 3Dprinted on Prusa MK3:
- in PLA (F3D Gold pearl),
- No support is needed,
- Infill 10%-20% gyroid.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: Place the Screw on the top face before slicing to avoid supports. I used 20% gyroid infill here.
Note3: I used 0.2mm layer height for Card trays to speed up the print.
Note4: I used 0.15mm first layer height and Monotonic top and bottom fill for Card separator to increase relief quality.

Printing Time (for one organizer of each kind):
01a: 9h14' - Resources container
01b: 2h51' - Resources lid
01c: 30' - Screw
02a: ~3h10' - Dwarf container
02b: ~1h - Dwarf lid
02c: 9' - Crystal
03: 2h6' - Event card tray
04: 2h22' - Project Card tray
05: 1h - Card separator
06: 4h26' - Token organizer