Micro Swiss DD w CR Touch Ender 3 Max Stock Fan mount
Micro Swiss DD w CR Touch Ender 3 Max Stock Fan mount
3D
Published 2021-10-26T11:59:13+00:00
I needed a mount for stock fan on my Ender 3 Max for the Micro Swiss Direct drive extruder. holmes4 had one listed for a BL Touch but the mounts didn't line up. But I'd like to thank him for the inspiration. I have a CR Touch and I wanted it on the right side anyway so I went to work. This is my 1st design so please be kind. After 9 reprints I finally came up with something that worked. Enjoy.
I wanted a place to mount a digital gauge for axis calibration so I added to the left side. That will be v11. Bonus: it also works for a BL Touch mount on the left side.
I also rounded the corners and reduced the thickness to 5 mm instead of 6mm. The only reason it was 6mm in the 1st place was because I didn't have any M3 5mm screws at the time. I do now and I think the 5mm thickness is better. I also made it where the nuts now fit better in the model.
Again enjoy
I printed it w/.16 layer height but I believe .28 even would work. 15% infill, PLA
| Date published | 26/10/2021 |
| Support Free | YES |