Shinx,Luxio,Luxray EVOLUTION 3 IN 1 PACK- FAN ART - POKÉMON

This is "Shinx,Luxio,Luxray" Evolution 3 IN 1 PACK" Evolution " from Pokémon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Shinx
Shinx is a quadrupedal, feline Pokémon resembling a lion cub or lynx kitten. Its front half is light blue, while the rear is black. There is a short tuft of fur on its head and smaller tufts on each cheek. The top tuft is smaller on the female Shinx. It has large, oval ears with yellow, star-shaped markings on the insides, yellow eyes, and a tiny, red nose. Whenever its mouth is open, small fangs can be seen in its upper jaw. A black marking encircles Shinx's neck like a collar, and there are yellow bands above its forepaws. The hind paws are black on the male Shinx and blue on the female. Spiked fur surrounds the base of its long tail, which is tipped with a yellow star shape. The fur can glow when electricity is used.

Luxio
Luxio is a feline, quadrupedal Pokémon resembling a young lynx or lion. Blue and black fur covers most of its body. Its ears, face, hind paws, and front half of its body are blue, while its hindquarters are black. Additionally, Luxio has a tufty black mane surrounding its face. The mane is longer on the male Luxio, while the fur on the hind paws extends to ankles on the female. The insides of its rounded ears are yellow, as are its eyes. There are two yellow rings around each front leg and a yellow, four-point star on the tip of its tail.

Luxray
Luxray is a quadrupedal Pokémon resembling a fully-grown lion. While its face, hind legs, torso, and the back of its front legs are blue, much of its body is covered with shaggy, black fur. The fur is longer around the shoulders and the base of the tail, and forms a mane on its head. The mane is larger on the male than on the female. It has yellow eyes with red sclerae, a blunt muzzle, and rounded ears with yellow insides. There are three yellow, half rings on the back of each foreleg. Its long, thin tail is tipped with a yellow four-pointed star.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.