AR15 Wall Mount

This is a wall mount designed to mount your AR15 to your wall. A magazine catch is included on both sides so it can be mounted with the barrel towards the right or the left.

A hole is included down the middle so a cable lock can be used by leaving the bolt of your Pew Stick open, feeding the cable into the ejection port, down the hole, and out the bottom.

Two mounting holes are included in the design. A slight bevel is at the mouth of each mounting hole if you choose to use normal framing screws. But larger pan head screws mounted to a stud in your wall are recommended.

This is only designed to fit Pew Sticks in a standard AR15 platform. It will not work with AR10 or AR9 specific lowers.

I recommend printing this in at least a 50% infill.

Print it in normal orientation with the bottom of the mount sitting right on the print bed. And I've had good success with having supports everywhere, small brim, then the supports can just be popped off at the magazine catch and the bottom mounting access hole.

I have tested the weight capacity after printing it on an ender 3 pro in both PETG and PLA+.
Both wall mounts easily held 175 pounds worth of weight before it even started to flex.
They look great with the Fuzzy Skin feature/setting in Cura. (As shown in Picture.)