Nintendo Switch Dock Cover - Pokemon

Cover for Nintendo Switch Dock. Easy to install, just slide it down. Easy to remove, just slide it up.

Designed for 3 color prints, so you can print the cover at once.

If you only have a 1-color printer, you can print separate parts and then paste all together with 1mm of relief.

It includes:

All parts needed for a 3-color printer (two backs, red&white, pokeball frame black, pokeball red half and pokeball white half+central dot).

Blank cover for those that have 1-color printer and the pokeball spare parts to print separately and paste them together.

*** Please, note that all the pieces are made to print together with no gap between the different colors because it's the way it works for 3-color printers. If you print the pokeball in a 1-color printer, you should adjust the tolerance using horizontal expansion setting, so you can paste all together without gaps between the pieces or without need of sanding the parts otherwise, you should sand a little bit the parts to make a perfect fit.

You might activate supports for the fixing hangs if you do not know how to configure good bridging. All the supports will be inner and not visible from outside.

Also you can print it without support if you configure properly the bridging.