Articulated Tail Flail for Transformers SS86 Gnaw

Gnaw's new Studio Series incarnation sure is a fun piece! But his single piece tail flail, being inarticulate, is something of a downer. Let's fix this then with our take on a multi-part articulated tail for him!

This kit comes as variously sized, connected tail segments which gives its a whole range of bendiness much as an actual whip-able flail should have!

Though designed to have 7 segments from handle to the spiked ball tip, it can also be "lengthened" by doubling up on some segments.

And while it's probably a little unclear from the photos, there are also two versions of the spiked ball tip provided - one with a pointier tips and another "safer" version with more rounded tips.

=== ASSEMBLY ===

All the segments connect together using short pieces of 1.75mm filament cut to length. Using the same colored filament as the prints themselves do help make it all like uniform!
Additionally, as they parts are quite small, they can be printed with more infill/shells for additional durability if you are looking to be messing around with them a lot :)

===

And there we have it - a more pose-able tail flail for the latest SS86 Gnaw! So happy 3d printing and have fun equipping your ravenous Sharkticon hordes with this! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog