Transformers Quintesson Hovercraft from G1 Episode "The Face of the Nijika"

Hovering into our realm of existence from the good 'ol days of the Generation One cartoons, here's the hovercrafts which the Quintesson and their Sharkticon cronies used to terrorize the poor Zamojin in the episode "The Face of the Nijika"

Sized to fit the WFC Quintesson Judge figure, the hovercraft comes equipped with a canon to rain destruction on whatever stands in its path. This was designed on a swivel and so the canon can be rotated to take aim on targets all around it!

Of course, the end of the canon barrel has been sized to fit effect parts, as are the twin thrusters at the rear of the craft!. There is also a single peg hole sited on the floor of the craft, for the Quintesson to be optionally pegged more firmly into place.

On both sides of the front console, 5mm ports allow for weapons and accessories to be attached and stored.

Also, on the underside of the hovercraft, there's a port in the middle which allows the craft to be affixed upon our earlier Tengristy Floating Display Base (https://www.patreon.com/posts/49214130). This should help give the entire setup a more dynamic look of floating and swooping down whilst firing away!

=== ASSSEMBLY ===
The image attached shows the various parts of this kit:

• A pair of Body_Peg pieces will help to align the Body_Upper and Body_Lower piece.

+The wings may need to be superglued to keep them firmly in place too.

===
As always, happy 3d printing this addon set to help the Quintessons keep their dastardly attacks on the poor Zamojin! :P

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog