Apple 3 in 1 charging valet station - iphone, airpods, apple watch and tablet stand

I was inspired by a wood charging station I saw for sale online that charges all three devices iphone, airpods, and watch all at once. I decided to make a similar version based off the photos but created completely from scratch and designed for 3d printing.

I created a version with and without tablet stand at the back if you want to store a ipad at the back.

Must use 2 apple brand lighting charging cables as well as a apple watch charging cable/puck. Only actual apple cables will fit the hole and cable routing slots.

Use 2 - m3x10mm bolts to secure each charger cable in the housing. The station has two holes in the back to install the m3 bolts.

0.2mm layer height or less to reduce layer marks on the side, you can get away with very low infill as this is not a structural type item. 10-20% infill. Make sure that your hole settings are calibrated as the holes for the charger cables are a tight fit. The plug for the watch charger is also a tight fit. I have to use 0.2mm hole horizontal expansion in cura to make holes come out to the correct dimensional size.

You should be able to print this without any support. The top section of the hex tablet holder should be able to bridge without an issue. Turn on "bridging" in cura if you are using that as your slicer.