Laegendary Legend 1:10 RC Car Front Bumper

This is a replacement bumper, designed for the Laegendary Legend 1:10 RC Car. 100% compatible with factory parts! The factory bumper uses 2 screws, Since 3d Printed parts tend to not be as flexible, i've designed the mount to use 4 screws. Simply remove the 2 screws for the bumper, and then 2 more in front of the control arms on the car. The Mount has a solid plate between them to help the bumper be more resilient and stronger. See the close up image of the test mount template i printed.

There are spots for 4 LED's, so if you want to splice into your wiring harness, you could add 2 additional lights, but i built the 2nd bar at the rear of the bumper with a spot to mount the LED's from the factory harness. The 2 LED mounts on the front are too far for the factory wiring, you you could splice your wire and use those or just use the 2 in the rear (like in the images i've provided) You could find a way to mount the LEDs in its holder but i designed it to snap into some 5mm LED mount clips i have.

LED Mount Clip:
https://www.amazon.com/gp/product/B01LX8JVG

I've also attached a picture of the Orientation i chose to try and limit supports in general, and specifically on more fratile parts (like the LED Brackets)

Check out the attached video (No Sound) to get some close ups of how this bumper fits etc.

Overall i'm quite pleased with the results, it took a few test prints to make sure i got sizing and spacing of parts down. This bumper is definitely rigid, I do suggest choosing a resin that is a bit more flexible. Sariya Tech Fast in "Smoky Black" is their "ABS Like" resin which i think is more durable than a lot of standard resins out there, and i mixed it 4 parts Fast with 1 part Tenacious (another sariya tech resin, very flexible). With this combo, the bumper definitely has a little bit olf flex to it. Please share any makes if theres anyone out there with this RC car!

-