iFactory One upgrade: infrared camera holder

ENGLISH:

Hello to all !

I own an iFactory One and I like this machine, I also like the fact that it is equipped with a raspberry camera, but I often print at night, and the camera becomes quickly useless, or requires to leave the light on all night to monitor or make a timelapse.

So I bought an infrared raspberry camera to allow filming anytime even without light.

So I created this adapter that clips easily on the camera and holds very well thanks to the small collar provided for this purpose) and is put on the original ball present on the iFactory.

Please check which version of infrared camera you buy, it must those or the plastic plate of the camera does not exceed (a new version is planned to accept this camera too.

The object is designed and turned by default to be printable on the iFactory without any support or part to be cleaned or recut, just print, clip the camera, put it on the ball and go.

ENGLISH:

Hello all :p

I own an iFactory One and I like this machine, I also like the fact that it is equipped with a raspberry camera, but I often print at night, and the camera quickly becomes useless, or asks to leave the light lit all night to monitor or do a timelap.

So I bought an infrared raspberry camera to allow filming anytime even without light.

So I created this adapter which clips the most easily in the world on the camera and holds very well thanks to the small collar provided for this purpose) and is put on the original ball present on the iFactory.

Please check which version of infrared camera you buy, you need the ones where the plastic plate of the camera does not protrude (a new version is planned to accept this camera too.

The object is designed and rotated by default to be printable on the iFactory without any support or part to clean or cut, just print, clip the camera, put it on the ball and go.

Created by Zoltan3D

ENGLISH:

On the iFactory, just put in the slicer and print, no need to support or turn the object,

Recommended nozzle: 0.4 or 0.6mm

In any case please orient it as in the photo of the slicer

ENGLISH:

On the iFactory, just put in the slicer and print, no need to support or rotate the object,

Recommended nozzle: 0.4 or 0.6mm

In all cases, please orient it as in the picture of the slicer