PVS-69 BINOC NVG

PVS-69.2 uses dual right side monocles and is optimized for printing the main bodies flat however, the bodies will also work printing vertically but i only recommend this if the threads are not turning out good horizontally. i also added a tool which can help screw in the sensor and a sensor screw with a slot that i made to fit my chisel but could fit a file or something similar.

A couple small changes have been made, as the left sensor screw would not work because the cutout was on the wrong side. i also added an STL for a J arm that allows you to print two of the right side housings and connect them in the binoc configuration

this is a working prototype for the PVS-69 NVG system. I am still actively making changes however i am confident enough in the current set up to release it. this design allows for focusing of the camera as well as the focal lens as well as adjustment of the operational angle using a bolt through the J arm. ignore the STL everything you need is in the .3mf

as stated this design is in a working prototype status and there are still small tweaks that eed to be made so please leave some comments describing any issues

You may notice theres no dedicated location to plug this in at. on the rear of the side panel theres and are which you can drill out and run your power cord through. currently i havent found a switch that i think suites this design so youll have to come up with your own i want this design to be as waterproof as possible so i suggest using teflon tape on the threads.

In the works i have a new bridge style with new J-arms

the electrical components you will need are
adafruit 2" NTSC/PAL tft
fpv camera you can use runcan pheonix, night eagle or you can use foxeer night cat
google cardboard vr headset (you will need the focal lenses form these)

Build tutorial is probably coming soon

.2 layer height