CARBONHOLICS HELLAS VSR - orsis t5000 se

1..back stock:

carbon tube or aluminioum 30mm outer 28mm inner diameter by 8cm
for connecting the back stock with the connector of the stock.
between then there are:
- 10mm rod by 14cm
- 1x10.6mm m5 screw rod
- 3x12.1mm m5 screw rod

as for the supports of the stocks these are:
- 2x 120mm m3 rods.
- 2x 115mm m3 rods.
- 1x 89mm m5 rod.
- 2x 82mm m8 rods for the middle section of the stock.
for monopod you need :
-1 x m6 nut
- 1x m6 by 50mm allen screw.

for the cheek riser you need:
- 2x 35mm m6 rod
- 1x 40mm m5 screw rod and a m5 thread insert for the riser nut.

for the butt stock extension you need:
- 2x45mm m6 rod
- 1x50mm m5 screw rod and a m5 thread insert for the riser nut.

2.. main body
for connecting the 2 parts together you will need:

-m3 x 328mm
-m3 x 325mm
-m3 x 283mm
-m3 x 290mm
-m10 x 25mm

at the back section of hole body you need 4 x m4 metal thread insert to put inside the 4 holes and 4x30mm m4 allen screws

for the pistol grip you need 2 x m5 metal thread inserts and 2 x m5 x 20mm allen screws

for the front section of the main body you need:
- 6x m5 metal thread inserts.

3..handguard
- 14 m4 metal thread inserts
- 14 m4 x 10mm allen screws
- 6 m5 x 8mm allen screws(fixed on the main body front section)
- 4 m5 x 15mm allen screws(back section of the handguard for fixing with the top rail of the receiver)

for supporting the handguard you need:
- 2x m3 320 mm thread rods
- 2x m3 370 mm thread rods
- 2x m3 375 mm thread rods
- 2x m3 150 mm thread rods
- 2x m3 50 mm thread rods

4..top rail of receicer
- 4 m5 metal thread inserts
- 4 x m5 x 15 allen screws.

all of the connecting parts and rods and inserts must be glued.

be advised that this project needs a lot of work to be finished properly.the construction is really well built and designed for durability and lasting.all solid parts needs to be glued.

there are fotos included exlaining the back stock that is complicated enough.

this project is not ment just to be printed.needs work on building it.it is tested on the fields.it is not just a preview.

2mm wall
0.12-0.10 layer
45 plus infeel(lines)
retraction need
custom supports need
speed 100-150(80 recommended)